Metabo HPT DS 18DFX Instructions De Sécurité Et Mode D'emploi page 16

English
Work
Machine
screw
Wood screw
Screw
tightening
(DS18DFX)
(DV18DFX)
Brick
(DV18DFX)
Wood
(DS18DFX)
Drilling
(DV18DFX)
Metal
12. Remaining battery indicator
You can check the battery's remaining capacity by
pressing the remaining battery indicator switch to light
the indicator lamp. (Fig. 15, Table 8)
The indicator will shut off approximately 3 seconds
after the remaining battery indicator switch is pressed.
It is best to use the remaining battery indicator as
a guide since there are slight diff erences such as
ambient temperature and the condition of the battery.
Also, the remaining battery indicator may vary from
those equipped to a tool or charger.
State of lamp
Lights ;
The battery remaining power is
over 75%
Lights ;
The battery remaining power is
50% – 75%.
Lights ;
The battery remaining power is
25% – 50%.
Lights ;
The battery remaining power is
less than 25%
Blinks ;
The battery remaining power
is nearly empty. Recharge the
battery soonest possible
16
Cap Position
For 1/4 in. (6 mm) or smaller
1 – 22
diameter screws.
For #16 (6.8 mm) or smaller
nominal diameter screws.
1 –
For #20 (8 mm) or smaller
nominal diameter screws.
For 1/2 in. (13 mm) or smaller
diameters.
For 1-1/2 in. (38 mm) or smaller
diameters.
Table 8
Battery Remaining Power
Table 7
Rotating speed selection (Position of the shift knob)
LOW (Low speed)
———
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
Remaining battery
indicator lamp
Display panel
HIGH (High speed)
For 1/4 in. (6 mm) or smaller
diameter screws.
For #10 (4.8 mm) or smaller
nominal diameter screws.
For 3/8 in. (10 mm) or smaller
diameters.
For 15/16 in. (24 mm) or smaller
diameters.
For 7/8 in. (22 mm) or smaller
diameters.
For drilling with a metal working
drill bit.
Blinks ;
Output suspended due to high
temperature. Remove the battery
from the tool and allow it to fully
cool down.
Blinks ;
Output suspended due to failure
or malfunction. The problem may
be the battery so please contact
your dealer.
Remaining battery
indicator switch
Fig. 15