Sharp 55FQ Guide De Démarrage Rapide page 7

EN
What is included in the box
Supply of this TV includes following parts:
• 1x TV
• 2x Remote control
• 4x AAA batteries
Attaching the Stand
Please follow the instructions on last page of this user manual.
Wall mounting the TV
Install the wall mounting bracket to the television as advised by the
bracket manufacturer.
Connections
Connecting external devices - see the last page of this guide.
Getting started - initial set up
1.
If rubber parts, foam parts or tape are attached to the TV frame, please
remove them gently.
2.
Using the antenna cable (not supplied), connect the TV to the antenna
wall socket.
3.
For connecting to the Internet with a wired connection connect a
Cat 5/Ethernet cable (not included) from the TV to your broadband
modem/router.
4.
Insert the batteries supplied into the Remote control.
5.
Connect the power cable to the Electrical outlet.
6. Then press Standby button to power on TV.
7. After turning the TV on, you will be welcomed by the First Time
Installation menu.
8. Pair your voice remote following the on-screen instructions.
9.
Select the language for the TV menu.
10. Please set desired settings in remaining screens of First installation
menu.
TV Control Stick
The TV control stick is located on the bottom left of the TV. You can use it
instead of the remote control to operate basic functions of your TV.
While TV is in standby mode:
• short press of control stick - Power On
While watching TV:
• RIGHT/LEFT – volume up/volume down
• UP/DOWN – changes channel up/down
• short press – Displays Menu
• 1x TV stand installation packet
• 1x Quick Start Guide
• 1x Power cord
• long press – Standby Power Off
While in menu:
• RIGHT/LEFT/UP/DOWN – navigation of cursor in on-screen menus
• short press – OK/Confi rm selected item
Choosing Mode Input/Source
To switch between the diff erent input/connections.
a) Using the buttons on the remote control:
1. Press [SOURCE] - The source menu will appear. Alternatively, you
can press and hold the
inputs.
2. Press [▲] or [▼] to select the input you require.
3. Press [OK].
b) Using the TV control stick:
1. Press the control stick briefl y to access the main menu.
2. Use the control stick to navigate to the [Inputs] menu.
3. Press the control stick briefl y to enter the [Inputs] menu.
4. Use the control stick to select your desired input/source.
5. Press the control stick to switch to the selected input/source.
TV Menu navigation
Use the (▲/▼/◄/►) buttons to focus on the desired item.
Press the OK button to select the item currently in focus.
Press the (back) button to go back one step in the menu.
Press and hold the (back) button to leave menu.
Press the (home) button to enter the TV Home menu.
Information on 144Hz Refresh Rate
This TV supports a 144Hz refresh rate for all resolutions up to 4K. However,
this is only available through HDMI 3 and 4 inputs. HDMI 1 and 2 inputs are
limited to 60Hz for all resolutions.
Similarly, VRR / AMD FreeSync™ is supported exclusively on HDMI 3 and 4.
If you intend to connect a gaming PC or console to this TV, please make
sure to use HDMI 3 or 4.
NOTE: To achieve 4K@144Hz, the connected device must output a video
signal at that resolution and refresh rate. The device must be connected
to the TV using an HDMI cable marked as "Ultra high speed".
Electronic instruction manual
To access more useful information directly from your TV, you can launch
the online manual by following these steps:
1. Press the
(home) button on your remote.
2. Using the cursor, navigate downwards to "Your apps".
3. From the list of apps, locate and select "Smart Portal".
NOTE: Please ensure that your TV is connected to the
internet in order to use this electronic manual.
Remote control
The TV comes with two remote controls.
The larger remote is used for the general control of the TV and is equipped
with a standard infrared (IR) transmitter.
The smaller multimedia remote is equipped with a microphone, allowing
you to control the TV with your voice. However, to enable voice control, the
remote must be paired with the TV via Bluetooth. Pairing is done during
the initial setup.
(TV guide) button to display the list of
EN