Ayce MIC Manuel D'utilisation page 26

Timer function
This function can be activated from any operating mode (normal operating mode or
stand - by mode).
Auto-start: with the appliance in STAND - BY, press the Timer
timer icon is displayed together with the time remaining before the appliance will
be turned ON. To adjust the timer, use the adjustment buttons" +" and" -", then
wait a few seconds for the setting to be memorised (timer value stops to flash for
2sec before get memorized). The stand-by icon is displayed together with the timer
icon (flashing icons), indicating that the timer has been set. When the programmed
time is reached, the appliance is turned ON with the settings used during the
previous period of operation.
Auto-off: when the appliance ON, press the Timer
displayed together with the time remaining before the appliance goes off. To set the
timer, use the adjustment buttons "+"and "-", then wait a few seconds for the
setting to be memorized (timer value stops to flash for 2sec before get memorized).
Once done the timer icon is shown during the normal operating mode, indicating
that the timer has been set. When the programmed time is reached, the appliance
is turned off automatically.
To go back to operation without the timer, press the timer
timer symbol disappears from the display.
Timer Steps: 0.5 Hr (30 minutes), 1 Hr, 2 Hr, 3 Hr, 4 Hr...23 Hr, 24 Hr, 0.
Every time one button is pushed the appliance emit "beep" sound. This function can
be activated/deactivated: when product is working push and keep pushing "-"
button until the display will show "b0" or "b1" flashing. Press "-" button to select
"b0" (beep off) or "b1" (beep on); waiting a few seconds for the setting to be
memorized.
TIP - OFF SAFETY DEVICE
This appliance is provided with a safety device which will switch off the heater in
case of accidental tipping off. To reset, disconnect the plug from the power for a
few minutes, remove the cause of tipping off, then plug the appliance in again. If it
still cannot be reset, return heater to your nearest service center for examination
or repair.
button. The
button. The timer icon is
button twice. The
OVERHEAT SAFETY DEVICE
Your heater is fitted with a safety device to switches off the heater in the event of
overheating. If the safety device operated, please turn the heater off, unplug the
appliance and let it completely cool, inspect for blockage of air inlet or outlet,
attempting to restart the heater then after.
If the heater fails to operate or the safety device switches the heater off again,
return heater to your nearest service center for examination or repair.
MAINTENANCE
1. Always disconnect the appliance and let it completely cool before any
maintenance.
2. Use a vacuum cleaner to remove dust on grilles.
3. Clean the outside of the unit with a damp cloth and then dry it with a dry cloth.
Never immerse the unit in water, nor let water drip into the unit.
STORING
1. Always disconnect the appliance, let it completely cool and clean it before storing.
2. If you do not use the device for a long period, put back the unit and the instruction
manual to the original carton and store in a dry and ventilated place.
3. Do not place any heavy items on top of carton during storing as this may damage
the appliance.
50 | 51
GB