Publicité
Les langues disponibles
Les langues disponibles
1.
Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle
could harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal
waste; it should be taken to a specialized company for recycling. This device should be
returned to your distributor or to a local recycling service. Respect the local environmental
rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, don't install or use it and contact your dealer.
2.
General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
3.
General Description
Product overview
1 Microphone
2 Indicator
3 Camera
4 Loudspeaker
5 Button 1 & 2 (for EDS101B)
6 Card Reading Area
7 IR Light (night view)
8 Micro SD Card Slot (Reserved) & Debugging Port
9 Rj-45 Network interface (POE port)
10 Terminals
Terminal and Wiring
NC: Door Lock Relay Output (NC)
NO: Door Lock Relay Output (NO)
COM: Common Interface
AIN1: For the access of Door Contact
AIN3: For the access of Exit Button
AIN2&AIN4: Reserved
485-: RS-485 Interface (Reserved)
485+: RS-485 Interface (Reserved)
12 VDC IN: Power Supply Input (not necessary if using POE via lan connection)
GND: Grounding
POE LAN: Network Interface
4.
Operation
4.1
Before You Start
•
Make sure all related equipments are power-off during the installation.
•
Tools that you need to prepare for installation: Drill (ø2.846) and gradienter.
4.2
Mounting
Install the video doorphone according to the installation instructions on page 4.
1.
Stick the mounting template on the wall. Drill screw holes according to the mounting template.
Remove the template from the wall.
2.
Secure the mounting plate on the wall with 4 supplied screws according to the screw holes.
3.
Connect the RJ45 network cable and signal cables for connection to a home automation system
and/or electronic lock. These outputs have a normal open relay contact. (see page 4).
V. 02 – 05/12/2023
EDS101S & EDS101B
USER MANUAL
5
©Velleman nv
Publicité
