Haussmann Xpert PNT147-R Manuel De L'utilisateur page 22

OPERATING PROCEDURES
CAUTION:
All air line components (including hoses, pipe, connectors, filters, & regulators,

etc.) must be rated for a minimum working pressure of 150 PSI or 150% of the
maximum system pressure, whichever is greater.
Disconnect the tool from the air supply before performing maintenance, clearing

a jammed fastener, leaving the work area, moving the tool to another location,
or handing it to another person.
PREPARING THE TOOL
1. After reading and understanding this entire manual, connect tool to air supply.
2. Turn on the air compressor and adjust the regulator to the proper pressure for
the fastener size you are using. (See the Using the Tool section below with
regards to adjusting this.)
CAUTION:
Keep the tool pointed away from yourself and others at all times.

Always disconnect the tool to air supply before loading fasteners.

Do not load fasteners with safety or trigger depressed.

Always wear approved safety glasses and hearing protection when preparing

or operating this tool.
Never use a tool that leaks air or needs repair.

LOADING FASTENERS
1. Press down latch, open feeder cover and magazine cover.
2. Adjust nail support to suit desired nail length. The nail support can be lifted
and rotated to three different positions that provide support for different length
is for 1-1/4" (32 mm) and 1-1/2" (38 mm) nails, and the upper position for 3/4" (19 mm)
3. Remove retainer from a coil of nails, uncoil approximately 3 nails, and
4. Close the magazine cover. Close and latch the feeder cover.
5.
away from the operator.
6. Adjust the shingle guide by loosening the retaining screw and sliding the
shingle guide can be used as an aid in positioning the shingle to be nailed at a
USING THE TOOL
Complete all the steps in PREPARING THE TOOL before using. This tool can be
SEQUENTIAL FIRE: (Fig.5)
1. Turn the trigger mode selector (A) so the tail of selector is up.
2. Put the contact tip of the tool on the working surface.
3. Lightly push the tool toward the working surface until the safety bracket is
depressed.
4.
most accurate fastener placement.
22
PNT147-R
!
!
A
Fig.5