Publicité
Les langues disponibles
Les langues disponibles
Cleaning outside the appliance
Before maintenance, switch off the appliance and disconnect the mains plug from the
mains socket. Use standard non-abrasive detergent diluted in warm water to clean the
outside.
The grille of the condenser at the back of the appliance and the adjacent components
can be vacuumed using a soft brush attachment.
Do not use harsh cleaners, scouring pads or solvents to clean any part of the appliance.
Moving the unit
▪ Location
Do not place your equipment near a heat source, for example. Stove, boiler or radiator.
Also, avoid direct sunlight.
When selecting a location for your appliance you should make sure the floor is flat and
firm, and the room is well ventilated. An average ambient temperature must be
observed. This temperature is specific according to the climatic class of the device:
N : This refrigerating appliance is intended to be used at ambient temperatures ranging
from 16 °C to 32 °C
▪ Do not turn on the appliance for 30 minutes
After any movement, it must not be connected for 30 minutes. This time allows the
coolant to adjust.
▪ Installation
Let your device breathe. Heat is released from the walls so it is important to leave
enough space around the appliance so the air can circulate.
Turn off your appliance
If the unit is not likely to operate for a long period of time:
▪ Remove all items from your appliance.
▪ Switch off the appliance by setting the thermostat to position "0".
▪ Unplug the appliance.
▪ Clean it thoroughly.
▪
Keep the door open to prevent odors from rising.
Changing the light bulb
This appliance consists of light-emitting diodes (LEDs). This type of diode cannot be
changed by the consumer. The lifetime of these LEDs is normally sufficient for no change
to be made. If, however, and despite all the care taken during the manufacture of your
23
Publicité
