Switching The Sample Clock - Tascam 8p Dyna Série Mode D'emploi

Connecting guitars and basses
When connecting a guitar, bass guitar or other high-impedance
output directly to this unit, use input jack 1 or 2 on the front of
the unit and set its input switch to INST.
NOTE
When connecting an instrument with active output or when
the sound passes through an effects unit, for example, set the
input switch to MIC/LINE
Connecting electronic devices and other
audio equipment
When connecting an electronic instrument or other audio
equipment, for example, to this unit, use a 1-2 jack on the front
of the unit and set its input switch to MIC/LINE.
Connecting analog record players
The output of an analog record player cannot be connected
directly to this unit. To connect an analog record player to this
unit, a phono amp and equalizer (or an audio amplifier that has
phono input jacks) must be connected between them.
Connecting digital equipment
Connect an OPTICAL OUT (S/MUX) connector on this unit to an
S/MUX input connector on a digital device.
12
TASCAM SERIES 8p Dyna

Switching the sample clock

Set the sample clock source to the unit's internal clock, and set
the sampling frequency.
The sample clock source can also be set to an external clock
(WORD IN).
1.
Press and hold the sample clock switch to put the unit into
sample clock setup mode.
The selected sample clock source will blink repeatedly at
short intervals.
2.
Press the sample clock switch to change the sample clock
source.
44.1k
48k
88.2k
96k
176.4k
192k
EXT
3.
After selecting the sample clock source, press and hold the
sample clock switch to confirm the setting.
NOTE
i This setting is retained even when the unit is turned off.
i When the EXT indicator is blinking and a valid word clock
signal is being input through the WORD IN connector, the
corresponding sample clock indicator will blink.