BWT ICE Serie Mode D'emploi page 4

Operation
Please use as much cable as
needed. Leave the remaining
cable out of the pool.
You may turn on
the cleaner when it
reaches the floor.
3.6 m / 11.8 ft
4
ICE LINE ROBOTIC POOL CLEANERS
Placement of the Power Supply
Place the power supply at least 3.6 meters / 11.8 feet from the pool and
at least 12 cm above ground. CAUTION: The power supply is not water
resistant; it must not be exposed to water or to direct sunlight.
Press the plastic snap on the zip ties in order to release the floating cable.
Use as much cable as needed in the water.
Before placing the cleaner unit in the water
Make sure there are no people in the pool. Make sure that the filters are
clean. Make sure the pool conditions are met; (see "Operating Conditions").
Placing cleaner in the water
Unroll the floating cable. It is recommended to extend a length of cable
that is equal to the diagonal size of the pool plus an additional two meters.
Smooth out coils or twists in the cable. Connect the floating cable to the
socket located on the power supply. Roll extra cable, not in the pool, near
the power supply. Place the robotic cleaner in the pool. Let it sink to the
bottom of the pool. Do not start operation before the robotic cleaner is
settled on the pool floor. CAUTION: Operating the cleaner out of water
12 cm / 4.7 inch
may cause immediate and severe damage resulting in loss of warranty.
above ground
Starting the robotic cleaner
Connect the power supply to the wall socket. The on/off button will light
up and the robotic cleaner will start its cleaning program. If the power
supply is already connected to the wall socket, the on/off button will flash
NO SWIMMING to indicate that the robotic cleaner is in standby mode. Press the On/Off
WHILE THE ROBOT
button in order to change the above mode (On to Off – standby, or vice
IS IN THE POOL
versa). Note: if the full filter indication light is ON make sure to remove and
clean the filter prior to putting the cleaner inside the pool water.