Rowenta RH8870W0 Mode D'emploi page 21

REPAIRS
IMPORTANT: If you notice that your vacuum cleaner is not functioning properly, before any
revision, turn it off by placing the Stop/Start button in the Stop position.
Repairs should only be carried out by specialists using original replacement parts. To attempt the
repair of an electronic appliance at home may be hazardous to the user.
If your vacuum cleaner does not start
Make sure that the charger is completely unplugged from the appliance. If it is, it means that the
appliance is not charged, so proceed to charge it.
If the 3 blue light charge signals start to flicker simultaneously and very rapidly when you plug the
charger to the vacuum cleaner, it means that you are not using the appropriate charger or that the
one you are using is faulty.
If your appliance does not vacuum
• The electro-brush is dirty: clean it.
• The separator is clogged up: remove the dust tray and clean the separator.
If your vacuum cleaner seems less efficient, makes noise or whistles
• The tube or the hose are partially clogged up: unclog them.
• The dust receiver is full: empty and clean it.
• The dust tray is not well positioned: place it correctly.
• The Delta vacuum head is dirty: demount the electro-brush and clean it.
• The foam rubber motor protection filter is saturated: clean it.
If the separator gets filled with dust
• The separator sometimes accumulates dust. Make sure that nothing is blocking the duct between
the separator and the dust tray.
• The dust tray opening is blocked: Remove the dust tray, empty it and clean the opening.
The vacuum head moves with difficulty
Lower the vacuum speed by moving the appropriate switch button.
If the problem persists, take your vacuum cleaner to the authorized Rowenta Service Center nearest
to your home. See the list of authorized Rowenta Service Centers or contact the Rowenta
Consummer Service department.
If your appliance gets overheated
The safety feature will turn on automatically. If the vacuum cleaner is being charged, the charge
stops. If the vacuum cleaner is being used, the motors stop and the 3 light battery charge signals
flash simultaneously and very rapidly.
In this case:
- turn off the appliance if it is on (set the Stop/Start button to Stop)
- or stop charging if the appliance is being charged (disconnect the charger)
- and let the appliance cool off for at least 1 hour.
GUARANTEE
This appliance is intended for domestic use only. In case it is used inappropriately, not following
the given instructions, Rowenta will not be subject to any liabilities whatsoever and the guarantee
will be invalidated.
Read the instructions before using the appliance for the first time: using the appliance in any way
different from the one indicated here would free Rowenta of all liabilities.
EN
20