UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
REAR PANEL
1. Media Player
Play music from an SD or USB
memory device.
2. Microphone Level
Adjust the signal level of
microphone.
3. Microphone Input
6.3mm ¼" input jack for
connecting a microphone.
4. Microphone Input
XLR input jack for connecting a
microphone.
5. Line Level
Adjust the signal level of line
input.
6. Line Input
RCA jack input for connecting
audio units with line level output
(e.g. mixer, CD player)
7. XLR Line Input
XLR jack input for connecting
audio units with line level output
(e.g. mixer, CD player)
8. MP3 Level
Adjust the level of media player.
9. Aux Input
3.5mm jack input for connecting audio units with line level output (e.g. mobile phone, CD player)
10. Line Output
XLR output jack for connecting an extra active speaker or audio unit with line level input.
11. Equalizer
5-band equalizer for the master signal. Adjust frequencies are 100Hz, 400Hz, 1kHz, 4kHz, 10kHz.
12. Master Volume
Adjust the overall output level of the portable sound set.
13. Power Indicator
Indicator lights up when power turned on.
14. Clip Indicator
Indicator lights up when signal level is too high. When the LED light up continually you must reduce the volume to
protect the speaker.
CONNECT BT DEVICE
1.
2.
3.
If password is required, you can enter "0000".
Set the search function on of the BT device you want to play the music. See the operating
instructions for that device..
Press the "MODE" button and activate BT-function of media player.
Find on your BT-device "VONYX" and make the connection
3