SNOWJOE sunjoe 24V-PS8CMAX-LTE Manuel De L'opérateur page 11

2. Screw the chain/sprocket end cover knob
counterclockwise to release chain/sprocket end cover
(Figs. 5 – 6).
Fig. 5
Chain/sprocket
end cover
Fig. 6
Chain/sprocket
end cover
3. Remove the bar and chain from the mounting surface
(Fig. 7).
Fig. 7
Cutting chain
4. Remove the old chain from the bar.
5. Lay out the new saw chain in a loop and straighten
any kinks. THE SHARP SIDE OF THE TEETH MUST
FACE AWAY FROM YOU IN THE DIRECTION OF THE
CHAIN ROTATION INDICATED ON THE GUIDE BAR
turn the loop over (Fig. 8).
R
Chain/sprocket
end cover knob
R
Guide bar
R
. If the teeth face backwards,
Fig. 8
Sharp cutting edge
Chain drive link
6. Starting at the tip, mount the chain drive links into the
bar groove, leaving a loop at the back of the bar. The
chain will loosely fit until it is placed on the sprocket
(Figs. 9 – 10).
NOTE: Make certain of the direction of the chain
backwards, the saw will vibrate abnormally and will not cut.
Fig. 9
Fig. 10
7. Hold the chain in position on the bar and place the loop
around the sprocket. Fit the bar flush against the mounting
surface so that the bar studs are in the long slot of the bar
and the adjusting pin is in the chain tension pin hole
(Fig. 11).
11
Chain rotation
. If the chain is mounted
Loop