SNOWJOE sunjoe 24V-PS8CMAX-LTE Manuel De L'opérateur page 10

Charging the Battery
1. Push the push lock button on the battery to pull the
battery pack out from the battery compartment (Fig. 1).
Fig. 1
2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, insert the
charger's plug into the electrical wall outlet. When you
plug in the charger, the top right green light will illuminate
and stay green (Fig. 2).
Fig. 2
Power on
green
3. Place the battery pack into the charger by sliding the
pack to lock it into position. When you insert the battery
into the charger, the top right green light will go off, and
the top left red light will illuminate to indicate that the
battery is charging (Fig. 3).
Fig. 3
Charging
red
24VCHRG-QC
quick charger
(Sold separately)
Fully
Charged
green
4. When the charger light turns green, the battery is fully
charged (Fig. 3).
R
Push button
Charger
Battery pack
NOTE: A fully discharged pack with an internal
temperature in the normal range will fully charge in 55
mins (between 32ºF/0ºC and 113ºF/45ºC).
5. If the light indicators do not come on at all, check that
the battery pack is fully seated into the bay. Remove
the battery pack and reinsert. If the problem persists,
contact an authorized Snow Joe
call the Snow Joe + Sun Joe
®
1-866-SNOWJOE (1-866-766-9563) for assistance.
6. When charging is complete, remove the battery from the
charger by pressing the push lock buttons and sliding the
battery backward to unlock it from the charger.
7. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
Assembly
m
DANGER!
Never start the motor before installing the
guide bar, chain, and chain/sprocket end cover. Without all
these parts in place, the clutch can fly off or explode, exposing
the user to potentially serious injuries.
Installing/Replacing Guide Bar +
Cutting Chain
Tools and supplies required:
• Hex key wrench (provided)
• Heavy-duty work gloves
NOTE: When replacing the guide bar and chain, use only
identical replacement parts. Make sure the pole chain saw
is disconnected with the battery before proceeding with
installation.
For your convinience, one extra replacement chain has been
included that can be used on this pole chain saw. Should more
replacement chain or other accessories is needed, visit
sunjoe.com to purchase.
1. Remove the hex bolt by screwing it counterclockwise with
the hex key wrench (Fig. 4).
Fig. 4
Chain/sprocket
end cover
10
+ Sun Joe dealer or
® ®
customer service center at
®
Hex key wrench
Hex bolt