Publicité
Les langues disponibles
Les langues disponibles
USER'S MANUAL
15A BATTERY CHARGER WITH LCD DISPLAY
SELECT
LCD DISPLAY
LiFePO4
Mode 1
(Only 12V Battery)
Mode 2
AGM
Mode 3
WET/MF
OPERATION
BEFORE USE
Before connecting the charger, the operating instructions must be observed.
Furthermore, the instructions of the vehicle manufacturer regarding a permanently connected car battery must be observed.
Secure the car, switch off the ignition.
Clean the battery poles. Take care that while doing so, your eyes do not come into contact with the dirt.
Ensure sufficient ventilation.
CONNECTING
Before start charging, please press the
START
Then press the
button. The charger start to work.
STOP
If you want to stop charging, please press the
The battery voltage display shows the current battery voltage after connecting.
If the connection is inverted or there is a short circuit, "Err" will be displayed on the screen.
The charger can automatically recognize and choose 6V or 12V voltage after connecting.
LCD display can automatically show the percent of voltage.
When the charger is charging, if the AC power supply is powered off, the charger stops charging. After the AC power supply is
powered on again, the charger will continue to charge in the charging mode before the AC power supply fails.
DISCONNECT
Disconnect the appliance from mains supply.
Remove the "-" pole clamp (black) from the "-" pole of the battery.
Remove the "+" pole clamp (red) from the "+" pole of the battery.
STATUT
Charging Lithium Batteries
Charging AGM Batteries
Charging WET/MF Batteries
button to select which mode you want.
MODE
START
button. The charger will stop.
STOP
MODEL: EWC612-15
USER'S MANUAL
5
Publicité
