Haier CFL634CW Notice D'utilisation page 12

Preparation prior to use
Connection to power supply
When the refrigerator is connected to power supply, the fridge temperature and freezer
temperature are automatically set to 5
Operation modes of the refrigerator
Manual adjustment mode: can set temperature by pressing the temperature setup key
(see "Function description" hereafter).
Loading the refrigerator with food
Load the refrigerator with food after it has been operates for
a period and the inside is cool enough.
Some time will be required for the refrigerator to reach the set temperature when
the setting is changed. The length of this period depends on the difference between
the existing and set temperatures, ambient temperature, door opening frequency
Note
and the amount of food in storage.
Safety instructions for installation
Never place the refrigerator in a damp area or location where it might be splashed with water.
Clean and dry water splashes and stains with a soft clean cloth.
The refrigerator should be placed in a well-ventilated place not far from a drink water source.
Ensure a space of at least 20 cm above and 10 cm around the refrigerator.
Keep ventilation openings in the appliance or in the in-built structure clear of obstruction,
The refrigerator is operated by a 220-240 VAC/50 Hz power supply. Abnormal voltage fluctuation
may cause the refrigerator to fail to start, or damage to the temperature control or compressor, or
there may be an abnormal noise when operating. In such case, an automatic regulator shall be
mounted.
A dedicated socket with reliable grounding must be provided for the refrigerator. The refrigerator's
power cable is fitted with a 3-pin (grounding) plug that fits a standard 3-pin (grounding) socket.
Never cut off or disassemble the grounding.
The appliance must be positioned so that the plug remains accessible.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
Do not damage the refrigerant circuit.
Safety instructions for installation
The Ice Maker and its water hose should be installed and tested by authorized professional
personnel.
Cut the water hose to the desired length while ensuring that it does not bend excessively.
Generally, its total length is not more than 5 meters. Longer hoses may reduce the water pressure
and produce poor ice making results.
The water hose should not be in contact with any heat sources as it is not heat-resistant.
The Ice Maker should be connected to a water source with a pressure between 150 and 700
Pascal.
Never install the Ice Maker hose in an area where the ambient temperature can drop to 0° C to
avoid icing.
The Ice Maker will start making ice when the internal temperature reaches -12° C.
After the device is positioned, the hose should be properly arranged to prevent it from being
crushed.
This Ice Maker must be supplied from a drink water source.
If the Ice Maker is used for the first time or after not being used for a longer period, the first loads
of ice cubes should be discarded as there may be impurities in the water hose.
For a newly installed refrigerator, please let the appliance operate for 24 hours before making ice.
The hose-set is delivered with the device and must be used. New hose-sets are only available via
the customer service.
Downloaded from Fridge-Manual.com Manuals
and -18 respectively.
9