Timberwolf TDS60 Manuel D'installation Et D'utilisation page 23

3.2 changing a top vent to a rear vent
In order to convert the venting confi guration from a top exit to a rear exit, remove components as illustrated. When
reinstalling in the alternate position: Check gaskets for tears, replace if necessary to ensure a proper seal.
Outer Top
Top Heat
Shield
7" (178mm)
Collar
7" (178mm)
Gasket
4" (102mm)
Collar
4" (102mm)
Gasket
installation preparation
4" (102mm)
Cover Plate
4" (102mm)
Gasket
Optional trivet required when converting
to rear exit.
7" (178mm)
Cover Plate
7" (178mm) Gasket
W415-2887 / 04.14.20
EN
23