Publicité
Les langues disponibles
Les langues disponibles
WARMING RACK AND COOKING GRATE (OPTIONAL RACK MODEL
PG24-1 NOT INCLUDED)
1. Install the Warming Rack and Cooking Grate as shown in Fig
Fig. 8
BURNER CLEAN-OUT
Every 20 hours of use, remove the grill grates, grease tray, and
heat deflector and clean the inside of the grill using a vacuum.
If you notice a lot of ash blowing around in the grill it is time to
vacuum it out.
FILLING THE AUGER TUBE
The first time you use your grill or any time the hopper has ran out
of pellets you will need to fill the auger tube. This simply means
you must fill the auger tube with pellets until pellets reach the
burner. This is done by turning the dial to the FEED position. The
auger will remain on for no more than 7 minutes. This is ample
time for the pellets to reach the burner. Once you hear pellets
dropping into the burner you can select your cooking temperature.
CONTROLLER EXPLANATION
POWER SWITCH
Used to turn the main power onto the pellet grill. The fan will be
on whenever the power switch is on. The dial must be rotated to
any of the other positions before the grill will start. If the power is
turned on with the dial in any other position than Shutdown the
grill will immediately start that function. "O" is Off. "-" is On. See
Fig. 9
Fig. 9
DIAL POSITIONS
SHUTDOWN -This setting must be used after each use. Turn
the dial to this setting and the fan will remain on. Wait for 10
minutes to allow the grill to finish burning any pellets in the
burner before turning the main power switch off. This setting will
burn up any extra pellets in the burner and cool down the grill. Do
All manuals and user guides at all-guides.com
WARMING RACK (OPTIONAL)
NOT INCLUDED
COOKING GRATE
not turn the main power switch off when the grill is hot.
FEED - This setting is used to feed pellets to the hopper. It will
be used the first time you use the grill to fill the auger tube and
any time you may inadvertently run the hopper out of pellets.
See instructions on filling the auger tube.
LOW SMOKE - This setting is used for smoking foods at an
average temperature of 160F. This setting will produce large
amounts of smoke.
HIGH SMOKE - This setting is used for smoking foods at an
average temperature of 220F. This setting will produce large
amounts of smoke.
175F TO 400F - There are 25F increment settings from 175F
to 400F. You can simply select any temperature you want
and the grill will control the temperature within 15F of the
selected temperature.
HIGH - This setting can be used to achieve temperatures up to
500F depending on ambient temperatures.
DISPLAY
LED FLASHING GREEN – The LED will flash green each time the
dial is changed from the OFF, SHUTDOWN, or FEED settings, to
any of the cook settings indicating that the grill is in the startup
cycle.
LED GREEN – A green LED light indicates that the grill in
functioning normally in any of the cook settings.
RED LED – The LED will be red when the dial is turned to the
shutdown mode or the flame is extinguished in any of the cook
settings.
LED Flashing Red – The LED will flash Red if there is an error
with the temperature sensor inside of the grill.
BREAKING IN THE GRILL
We suggest turning the grill to 350F for ½ hour before
cooking on the grill for the first time. This will burn off any
manufacturing oils and cure the paint. Make sure to follow
the instructions for filling the auger tube before breaking in
the grill.
WARNING
Always start the grill with the lid open.
The lid must be closed after the
start cycle.
Publicité
