Publicité
Les langues disponibles
Les langues disponibles
Charge only at ambient temperatures between 10 °C
u
and 40 °C.
Charge only using the charger provided with the tool.
u
When disposing of batteries, follow the instructions
u
given in the section "Protecting the environment".
Chargers
Use your BLACK+DECKER charger only to charge
u
the battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and
damage.
Never attempt to charge non-rechargeable batteries.
u
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
$
u
The charger is intended for indoor use only.
+
Read the instruction manual before use.
w
Fail safe isolating transformer. The mains
supply is electrically separated from the
transformer output.
x
The charger automatically shuts off if the
ambient temperature becomes too high. As a
consequence the charger will be inoperable.
The unit must be disconnected from the
mains supply and taken to an authorised
service centre for repair.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the
charger unit with a regular mains plug.
(Original instructions)
If the supply cord is damaged, it must be replaced by
u
the manufacturer or an authorised BLACK+DECKER
Service Centre in order to avoid a hazard.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Features
This tool includes some or all of the following features.
1. On/off switch
2. Forward/reverse slider
3. Bit holder
4. LED work light
5. Charger
6. Charger plug
7. Charging connector
Assembly
Fitting and removing a drill bit or a screwdriver
bit (fig. B)
This tool uses screwdriver bits and drill bits with a 6.35
mm (1/4") hexagonal shank.
To fit a bit, insert the bit shaft into the bit holder (3).
u
To remove a bit, pull the bit shaft out of the bit holder
u
(3).
Note: The right angled attachment shown in fig. E-J may
not be included with your tool.
Use
Warning! Let the tool work at its own pace. Do not
overload.
Before first use, the battery must be charged for at
u
least 15 hours.
Charging the battery (fig. C)
Insert the charger plug (6) into the charger connector
u
(7).
Plug in the charger (5).
u
Leave the tool connected to the charger for 15 hours.
u
The charger may hum and become warm while charging;
this is normal and does not indicate a problem.
ENGLISH
7
Publicité
