16
3.
5.
min.
17 oz. /
500 ml
7.
5 sec.
!
IMPORTANT
The descaling program runs for about
20 minutes.
Bosch Home Appliances
TAS55_UC.indb 16
All manuals and user guides at all-guides.com
4.
6.
20 min
3. Fill the water tank up to the descaling
mark (0,5 l) and add the descaling agent
in accordance with the manufacturer's
instructions.
Note:
i
If you have hard water, increase the
amount of descaling agent.
4. Replace the water tank by tilting it
slightly and returning it to its original
position until it clicks into place.
5. Place a container with a capacity of
at least 17 oz. / 500 ml under the drink
outlet.
6. Open the brewing unit by lifting the
handle (4a) and then pushing the
brewing unit up. Place the Service
T DISC on the T DISC holder (4b) with
the barcode facing down. Make sure
that the l ap of the T DISC is located in
the slot in the front.
Close the brewing unit by i rst bringing it
►
down and then pushing the handle (4a)
i rmly to the machine until you hear an
audible click.
7. Press and hold the Start / Stop button
(2) for at least 5 seconds to start the
descaling program.
Release the Start / Stop button after
►
5 seconds; the machine will run the
descaling cycle automatically. This is
indicated by the Status LED
"Descale required" LED
Note:
i
The descaling solution is pumped through
the machine in intervals and then runs into
the container until the water tank is almost
empty. A small amount of liquid is always
left in the tank.
en
and
F
blinking.
'
16.12.2011 13:45:14