HAIRCUT PROFESSIONAL TH38 Manuel D'utilisation page 22

▪ Before the end of the autonomy period, the charge light flashes.
Charge the battery, refer to § 3.1.
▪ The clippers can be used with the electrical lead. For this, connect the cable to
the clippers (Fig. 2a) and connect the power pack (Fig. 1-K) to a mains power
socket.
A
DJUSTING THE CUTTING HEIGHT WITH THE LEVER
The cutting height can be adjusted during use of the clippers, with the adjusting
lever (Fig. 1-C):
▪ Push the lever upwards to reduce the cutting height.
▪ Push the lever downwards to increase the cutting height.
U
SING THE COMB ATTACHMENTS
▪ The clippers
(Fig. 1, refs. E-I).
▪ Place the comb attachment on the blade and clip it in at the rear. When the
comb attachment is correctly fixed, it is immobilized.
R
EPLACING THE BLADE
▪ Switch the clippers off and unplug the power pack from the mains power supply.
▪ Take the screws out of the blade (Fig. 3) and remove the upper and lower
cutters.
During their assembly, the upper and lower cutters must be aligned as instructed
below:
▪ Set the adjusting lever to the minimum cutting height.
▪ The distance between the front edge of the lower cutter and the front edge of
the upper cutter must be between 0.8 mm and 1.5 mm.
▪ The upper and lower cutters must be set parallel.
▪ The end tooth on the upper cutter (on the left-hand end) must cover the end
tooth on the lower cutter.
▪ The other end tooth on the upper cutter (on the right-hand end) must also touch
the corresponding end tooth on the lower cutter (on the right-hand end).
▪ Tighten the two screws (Fig. 3).
must be switched off. Select
22
a comb attachment