HAIRCUT PROFESSIONAL TH38 Manuel D'utilisation page 21

 WARNING: To recharge the battery, use
only the removable power pack supplied
with the equipment.
When charging, it is advisable to switch the clippers off (On/Off button set
to 0, Fig. 1-B).
C
HARGING THE CLIPPERS FROM THE MAINS SUPPLY
▪ Insert the electrical lead into the socket of the clippers (Fig. 2a).
▪ Connect the power pack (Fig. 1-K) to a mains power socket.
▪ During charging, the indicator light flashes.
▪ At the end of charging, the indicator light comes on steadily. Unplug the power
pack. The clippers can then be used without the electrical lead.
C
HARGING THE CLIPPERS ON THE CHARGE STAND
▪ Insert the electrical lead into the charge stand socket (Fig. 2b).
▪ Insert the power pack in a mains power socket.
▪ Put the clippers on the charge stand (Fig. 1-K).
▪ At the end of charging, the indicator light comes on steadily. The clippers can
then be used without the electrical lead.
OPERATION
When first used, lubricate the cutters by applying a drop of oil to the points
shown (Fig. 4).
S /
WITCHING ON OFF
▪ Switch the clippers on by pressing the On/Off button (Fig. 1-B). The button lights
up.
▪ To stop the clippers, press the On/Off button again (Fig. 1-B). The button goes
out.
▪ When the clippers are not in use, it is advisable to clip the blade cover (Fig. 1-N)
onto the blade.
U
SE WITH OR WITHOUT ELECTRICAL LEAD
▪ With a new, fully charged battery, the clippers can be used without the power
lead for about 120 minutes.
Use only with the
HP12D-0502000-AE power
pack
21