Hilti NPR 032 PE-A22 Mode D'emploi page 24

5.5.3 Position/stroke table
Pos. Stroke Application
1 40 mm 12.0 mm ... 66.7 mm
(with NPR PS M & NPR PR M)
16.0 mm ... 75.0 mm
(with NPR PS G & NPR PR G)
12.0 mm ... 108.0 mm
(with NPR PS V & NPR PR V)
12.0 mm ... 63.0 mm
(with NPR PS TH & NPR PR TH)
12.0 mm ... 110.0 mm
(with NPR PS U & NPR PR U)
2 80 mm 76.1 mm ... 108.0 mm
(with NPR PR M)
3 100 mm Industrial application
5.6 Fitting the crimping / pressing jaws
WARNING
Risk of injury! Unintentional starting.
▶ Remove the battery before fitting, changing or removing the crimping / pressing jaws.
Never operate the crimping / pressing tool without crimping / pressing jaws in place.
To ensure correct crimping and reliable and safe operation, use only the crimping jaws approved by
the system provider and/or machine manufacturer.
1. Remove the battery and select the most suitable crimping / pressing jaws.
2. Press the locking pins.
3. Rotate the locking pins counterclockwise as far as they will go.
4. Pull out the locking pins.
5. Fit the crimping / pressing jaws.
6. Push the locking pins in until they engage.
7. Rotate the crimping / pressing head to the desired working position.
The crimping / pressing head can be rotated much more easily when not under pressure.
5.7 Removing the crimping / pressing jaws
WARNING
Risk of injury! Unintentional starting.
▶ Remove the battery before fitting, changing or removing the crimping / pressing jaws.
1. Remove the battery and rotate the crimping / pressing head into the outset position.
2. Press the locking pins.
3. Rotate the locking pins counterclockwise as far as they will go.
4. Pull out the locking pins.
5. Work the crimping jaws forward and out of the product.
5.8 Fitting the adapter jaws and pressing ring
WARNING
Risk of injury! Unintentional starting.
▶ Remove the battery before fitting, changing or removing the crimping / pressing jaws.
20 English
3
4
2215657
*2215657*