Hilti NPR 032 PE-A22 Mode D'emploi page 21

3 Description
3.1 Product overview
3.2 Intended use
The product described is a cordless electro-hydraulic crimping tool.
It is designed for crimping fittings used to connect composite, copper (Cu) and steel pipes.
Use only Hilti lithium­ion batteries of the B 22 series with this product.
•
• Use only Hilti-approved battery chargers to charge these batteries. More information is available from
your Hilti Store or from www.hilti.group
3.3 Possible misuse
• Do not use this hand-held product clamped in a fixed position or as a stationary device.
• This electro-hydraulic crimping tool may not be exposed to heavy rain or used under water.
3.4 Lithium­ion battery status display
The charge state of the Li-ion battery and malfunctions of the product are indicated by the indicator of the
Li­ion battery. The state of charge of the Li­ion battery is displayed after pressing one of the two battery
release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED flashes.
Battery state of charge cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch. If the LEDs of the charge state indicator flash, follow the instructions
in the 'Troubleshooting' section.
*2215657*
1
2215657
Crimping / pressing head
@
Key ring
;
Casing
=
Servicing and fault indicator (red LED)
%
Battery release button
&
Battery
(
Control switch
)
Tubular guard for adjusting
+
(shortening/extending) the stroke
Locking pin for opening/closing the tool head
§
Crimping jaw holder
/
Pressing ring with adapter jaws
:
White LED to illuminate the working area
∙
Manual piston return switch
$
Meaning
State of charge: 75 % to 100 %
State of charge: 50 % to 75 %
State of charge: 25 % to 50 %
State of charge: 10 % to 25 %
State of charge: < 10 %
English 17