Panasonic CU-E21QKE Comment Utiliser L'appareil page 6

How to use
POWER TIMER
(Green) (Orange)
ECONAVI
To optimise energy saving
MODE
To select operation mode
AUTO - For your convenience
HEAT - To enjoy warm air
COOL - To enjoy cool air
DRY - To dehumidify the environment
MILD DRY
To improve humidity and
COOLING
moisture level
• This operation reduces air dryness and
Single
provides you with a comfortable living
environment during COOL mode only.
• When vertical airfl ow direction is set to
AUTO, it stops at lower position to avoid
cold air contact. However, you can adjust
the louver direction manually.
• Function not applicable.
Multi
POWERFUL/
To switch between
QUIET
powerful & quiet
POWERFUL QUIET
POWERFUL: To reach temperature quickly
POWERFUL
• This operation stops automatically after
Single
20 minutes.
• Press the button again or turn OFF the
Multi
unit to stop this operation.
QUIET: To enjoy quiet operation
QUIET
• This operation reduces airfl ow noise.
Auto OFF/ON button
AUTO
OFF/ON
6
AUTO COMFORT NANOE-G
(Green) (Blue)
NORMAL
Use when remote control is misplaced or a malfunction occurs. Raise the front panel:
1. Press the button once to use in AUTO mode.
2. Press and hold the button until you hear 1 beep, then release to use in forced
COOL mode.
3. Repeat step 2. Press and hold the button until you hear 2 beeps, then release to
use in forced HEAT mode.
• Press the button again to turn off.
POWERFUL QUIET
(Orange) (Orange)
Remote control display
AUTO
HEAT
COOL
DRY
MILD
DRY
OFF/ON OFF/ON
ECONAVI
MODE
MILD DRY
TEMP TEMP
COOLING
POWERFUL/ /
QUIET FAN SPEED
TIMER TIMER
ON ON
1 1
2 2
OFF OFF
SET CHECK CLOCK CHECK CLOCK
FAN SPEED
To select fan speed
Remote control display
(
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
Single split system
Single
Multi split system
Multi
Human activity
sensor
Sunlight sensor and
remote control receiver
FAN
SPEED
AIR
SWING
AUTO
COMFORT
NANOE-G
Press and hold for
approximately
10 seconds to show
AIR SWING
temperature setting in
°C or °F.
SET SET
3 3
Press to restore the
remote control to
CANCEL CANCEL
default setting.
AC RC
RESET
Not used in normal
operations.
)
(Green)
Indicator