Beper P204FER200 Manuel D'instructions page 10

Travel Iron Use Instructions
Description of the product Fig. A
1. Soleplate
2. Steam switch
3. Thermostat
4. Volt slide button
5. Working indicator light
6. Foldable handle
7. Steam button
8. Water tank lid
9. Water tank
10. Handle lock/unlock button
11. Power cord
Attention: the soleplate is very hot, do not touch during use!
Keep the iron away from children.
Ironing
After preparing all the necessary for the ironing, unroll the power cable and check that it is free from knots or
tangles.
Lift the handle by pressing the appropriate button.
Attention: before connecting the plug to the mains, check that the voltage selection button is posi-
tioned correctly according to the mains voltage in the country where you are located
Check if the water tank is full; if you want to use steam, you should fill the tank with water (see the specific pa-
ragraph).
Turn the thermostat to the position "MIN".
Fill the water tank with sufficient quantity.
Place the iron vertically, paying attention that the soleplate will not come in contact with objects or anything else.
Insert the plug into the socket.
Set the thermostat to the desired temperature, referring to the symbols printed on the thermostat.
At this point, you can start ironing.
Steam ironing
To iron with steam move the steam switch to the back.
When using the iron for the first time, press several times on the steam shot button, so that the impurities that
during the construction of the iron deposited inside the holes will be eliminate.
Steam ironing is possible by adjusting the thermostat to the position marked by the symbol (•); increasing the
temperature also increases the jet of steam, up to the maximum marked by the symbol (•••).
The working indicator light turns on and when the soleplate will reach the temperature (temperature that allows
the steam to escape) it switch off.
Press the steam shot button and the steam will come out.
Respect a 5 seconds interval between one shot of steam and another.
If the steam shot button will be press before reaching the set temperature, the water will not come out vaporized
but will drip from the plate; this can cause ironing spots on the garment.
Water dripping can also be caused by prolonged pressure of the steam jet button. (More than 5 seconds)
At the end of the operation, place the iron in vertical position and disconnect the plug from the socket.
The iron must be constantly on movement on the fabric to be ironed.
Warning: always direct the steam jet in the direction of the garment to iron, never towards the face.
After ironing, always empty the tank of the remaining water, after having unplugged the plug from
the electrical socket.
Dry ironing
To dry iron move the steam switch forwards to deactivate the steam outlet.
Adjust the soleplate temperature by turning the thermostat.
The working indicator light turns on and when the soleplate is at temperature it turns off.
Start ironing after the iron has reached the desired temperature.
10
S