Télécharger Imprimer la page

Caractéristiques Techniques - Conrad Electronic 81 25 37 Notice D'emploi

Pistolet à air chaud 2000w de 8 pièces

Publicité

Elimination des éléments usés
Lorsque le produit n´est plus en état de marche ou que toute réparation est vaine,
veillez à son élimination conformément aux dispositions légales en vigueur.
Maintenance et nettoyage
Consultez les consignes de sécurité avant de commencer le nettoyage de
l´appareil. Nettoyer le produit uniquement avec un chiffon humide ou un pinceau. Ne
pas utiliser de nettoyants agressifs ou de solutions chimiques car ils pourraient
endommager le produit.
Caractéristiques techniques
Alimentation électrique:
230V AC / 50 Hz
Consommation :
Niveau I env. 1000W, niveau II env. 2000W
Débit d´air :
Niveau I 500l/min,
Température de l´air:
Niveau I 300°C,
Classe de protection :
II
Longueur câble de connexion :
env. 1,6 m
Poids :
env. 0,7 Kg
20
niveau II 650l/min
niveau II 600°C
Introduction
Dear customer,
Thank you for purchasing this hot air blower.
This product reflects the latest state of technology.
It fulfils the requirements of the valid European and international guidelines. The con-
formity was proven and the corresponding declarations were deposited with the
manufacturer.
In order to maintain this condition and ensure safe operation, you as the user have to
observe this operating manual.
In case of questions, consult our technical information service
Germany: Tel. 0180/5 31 21 17 or 09604/40 88 45
Fax 09604/40 88 48
e-mail: tkb@conrad.de
Mon - Fri 8.00 to 18.00
Austria: Tel. 0 72 42/20 30 60 · Fax 0 72 42/20 30 66
e-mail: support@conrad.at
Mon - Thu 8.00 to 17.00
Fri. 8.00 to 14.00
Switzerland: Tel. 0848/80 12 88 · Fax 0848/80 12 89
e-mail: support@conrad.ch
Mon - Fri 8.00 to 12.00, 13.00 to 17.00
Intended Use
This electronic device is intended for thawing, disinfection, paint removal, gluing, sol-
dering, melting, shrinking, welding, drying and forming.
The appliance may only be operated with 230 Volt / 50 Hz (10/16 A) AC voltage.
Application is restricted to closed, dry rooms. The contact with moisture has to be
avoided at all costs. This product is not intended for industrial use.
It is also not intended for any other use than the one described before. In addition,
this is connected to risks like short circuit, fire, electric shock or similar.
The safety notices have to be observed under all circumstances!
9

Publicité

Chapitres

loading