Publicité
Les langues disponibles
Les langues disponibles
Before powering on the kit, be sure that the output voltage on the connector is
CAUTION!
115 Vac.
For installation on pumps that are not equipped with a screw cap,
use the flange system provided with the pump as shown in the
following figure.
Figure 4 Installation on a Pump not Equipped with a Screw Cap
For installation on a pump whose controller is not equipped with a
115 Vac valve power supply socket, remove the connector after
cutting the controller power cord and connect it to module J21 as
shown in the previous figure.
Turbo-V Vent Valve 87-900-947-01 (F) User Manual
Installation procedure
Installation
TO RELAY COIL
MECHANICAL PUMP
4
37/44
Publicité
Chapitres
