Publicité
Les langues disponibles
Les langues disponibles
4
Installation procedure
Installation
Once the kit is assembled, install it on the pump.
For pumps equipped with a screw cap, once the screw cap is
removed use the appropriate adapter to secure the valve to the
pump.
The following figure shows a tipical installation on a pump equipped
with a screw cap.
Figure 3
Upon completion of the mechanical installation, attach the Turbo-V
vent valve controller unit power cord to the related connector on the
rear panel of the Turbo pump controller.
36/44
1 NEG = BLUE
2 POS = BROWN
3 GND = Y/G
YELLOW-BLUE
BLUE
BROWN
Installation on a Pump Equipped with a Screw Cap
Turbo-V Vent Valve User Manual / 87-900-947-01 (F)
M8/M5
OUT
DUPLICATED J7
CONTROLLER
115 Vac 1A Max
FROM MECHANICAL
PUMP RELAY COIL
POWER CORD
Publicité
Chapitres
