Vito Agro VIBCTPBSFL20 Mode D'emploi page 30

Before carrying out any maintenance or cleaning
work, place the cordless pruning shears on a level
surface, turn off the motor and remove the battery.
The blade must be lubricated daily so that it does not run
out of oil.
Whenever you add oil have the blade must be open.
1. Place the shears in a horizontal position;
2. By using the inner wrench (7), remove the bolt;
3. Use the oil bottle (8) supplied, to add oil to the hole;
4. Without turning the pruning shears upside down, install
the battery (4) and press the trigger (6) several times to
lubricate the entire blade;
5. Remove the battery to tighten the bolt.
Always check the blade tension before using the pruning
shears. If the blade is properly tensioned, the battery life
will be extended.
1. Place the shears in a horizontal position;
2. By using the inner wrench (7) slightly loosen the bolt;
3. Use the outer hex wrench (9), to adjust the blade tension;
Do not overtighten!
4. Retighten the bolt and check that the blade tension is
correct.