MZ electronic CC011 Instructions D'utilisation page 23

English
Components
The package contains:
Chain counter
Sheet with QR link to the online manual
Installation
Installing the magnet on the anchor windlass
A hole having a diameter of 6.5 mm (~1/4") and depth of 8 mm (5/16") must be drilled on
a tooth of the gipsy, in a place outside the chain's path.
In the case of vertical shaft anchor windlasses (see Fig. 1B), drill the hole in the lower
circumference of the gipsy.
In the case of horizontal shaft anchor windlasses (see Fig. 2B), drill the hole in the outer
circumference of the gipsy.
Also make sure that the protruding part of the magnet will not collide with the base or
sensor during rotation of the gipsy.
Insert the metal part of the magnet in the hole, allowing the protected part to protrude by
about 2 mm. Fix it in place using an adhesive for metals (two-component epoxy glue) or
silicone. The glue used must be able to withstand a marine environment.
Drilling template
Rev. 01 – 2024
CC011 23