DS Produkte EFP-005 Mode D'emploi page 12

EN
The device must always be disconnected from the mains power
■
when it is left unattended and before assembling, disassembling
and cleaning the device.
In the interest of your own safety, you should inspect the device
■
for damage each time before you use it. Only use it if the device,
mains cable and mains plug have no signs of damage!
If the device, the mains cable or the mains plug of the device is
■
damaged, it must be replaced by the manufacturer, customer
service department or a similarly qualifi ed person (e. g. specialist
workshop) in order to avoid any hazards.
Never immerse the device, mains cable or mains plug in water
■
or other liquids and ensure that these components cannot fall
into water or become wet.
ATTENTION: Note the cleaning instructions in the "Cleaning and
■
Storage" chapter!
The device is not designed to be operated with an external timer
■
or a separate remote control system.
Risk of Injury
■ Warning of suffocation! Keep children and animals away from the packaging
material.
■ Beware of the risk of scalding from heat, hot steam or condensation! Use
suitable oven gloves when handling the device.
■ Beware of falling! Make sure that the connected mains cable does not present a trip
hazard. The mains cable must not hang down from the surface on which the device
is placed in order to prevent the device from being pulled down.
Danger of Electric Shock from Water!
■ Use the device only in closed rooms.
■ Should the device fall into water, switch off the power supply immediately. Do not
attempt to pull the device out of the water while it is still connected to the mains
power!
■ Never touch the device, mains cable or mains plug with wet hands when these
components are connected to the mains power.
Warning of Electric Shock from Damage and Inappropriate Use!
■ Only connect the device to a plug socket with safety contacts that is properly installed
and matches the technical data of the device. The plug socket must also be readily
accessible after connection so that the connection to the mains can quickly be
isolated.
12