Costway TS10130 Mode D'emploi page 5

4
2
1
3
3
Install the front wheel
Front fork
Nut
Hook
Front wheel
08
1 Standard fixing position of brake
spring
2
Increase elasticity
3
Decrease elasticity
This item is applicable to the
packaging method without assembling
the front wheel
Install the front wheel into the front fork,
put on the safety hook and nut in turn,
adjust the gap between the wheel and the
front fork leg to be equal, and then tighten
the nut (The screwing torque of 3/8 core
is 30N.m or more, and 18N.m or more of
5/16 core).
4
Fixing the training wheels
Remove the protective caps on the axle of the rear wheel. Unscrew the nuts, and
put the training wheel on. Then screw on nuts again.
Note: Before the nuts are fully tightened, you can adjust the training wheel up or
down to make the bottom of the training wheel have a clearance less than 0.2"
(5mm) up from ground.
Tighten the nut, the torque is not less than 30N.m
IMPORTANT
1. For safety, the nuts should be screwed tightly.
2. The ear of the positioning washer should be fixed in the clearance of the
rear fork.
5
Fixing the Pedals
Check the end of the
Pedals and find out which
one is for the left and
which one is for the right.
Screw the right Pedal to
the right crank and
tighten it. Then fix the left
Pedal.
"R": for right
"L": for left
positioning
washer
09