Magnat NEO FLEX 130 Mode D'emploi page 10

GB
CONNECTING TO THE POWER AMPLIFIER (FIG. 1)
The subwoofer should be connected to an external power amplifier in every case. This
can provide the required electrical power and create corresponding dynamic reserves.
The relevant instructions also contain the customized connection diagram for the
operation of a subwoofer.
The basic equipment of a power amplifier also includes an active crossover switch
(low-pass) to keep undesirable mid-tone ranges away from the subwoofer.
FIGURE 1
A Mono Subwoofer
B Stereo Subwoofer
1. car radio
2. Y adapter
3. 2-/4-channel amplifier
4. satellites
5. capacitors (optional)
6. bridged mode
7. subwoofer
ADDITIONAL PASSIVE FILTERS (FIG. 2)
Should you not have any active filter switching available (e.g. use of a mono-block or
tri-mode two-channel power amp), this function has to be performed by a passive
crossover. Please select your subwoofer's cutoff frequency and wire the components
as follows.
10