Publicité
Les langues disponibles
Les langues disponibles
This program allows you to charge / discharge your Ni-xx batteries. The work principles are the same for Ni-Mh and Ni-Cd, only the delta Peak
values are different following the program you choose. Please make sure to attach the matching batteries (Ni-Mh or Ni-Cd) when using one or
the other program.
This function allows you to charge your Ni-xx battery. Just indicate the maximum charge current, and launch the
charge process. End of charge will be detected depending of the delta Peak values entered in the "User Set Program"
Charge
-> "Ni-xx sensitivity".
This function allows you to cycle your batteries to bring them back to their optimal performances, or to get rid of
the "memory effect" of the battery. Nickel batteries develop a memory effect when they are not used / discharged at
Cycle
their maximum capacity. After some time, they memorize the capacity requested during the last operations and will
behave as if they had that capacity as a maximum. Cycling them from time to time will allow them to recover their
full performances. You can select the number of cycles ( from one up to 5), and you can check the current drawn
or charged on the screen once the process launched.
This functions allows you to discharge your battery with a current between 0.1 Ah and 1Ah, and a discharge
voltage limit between 0.1 and 25 Volts. The voltage you will input must match the voltage of the battery pack, not
Discharge
the voltage of a single cell ( expect if you connect a single cell to the charger).
« Nim-Mh / Ni-cd » battery program
Publicité
