Publicité
Les langues disponibles
Les langues disponibles
CHECK TIRE PRESSURE
Check the air pressure in all tires before use. Improper air
pressure will affect handling, steering response, traction,
tire life, level cutting, and operator comfort. Be sure tires are
inflated to the pressure shown below.
NOTE: Tire pressure should only be measured or adjusted
when tires are cold.
Recommended
Pressure
WARNING:
Check the tire pressure carefully while inflating. Too much
air in the tire could cause the tire to burst, causing seri-
ous personal injury.
VERIFY MOWER CONDITION
Inspect the entire product for damaged, missing, or loose
parts such as screws, nuts, bolts, caps, etc. Tighten securely
all fasteners and caps and do not operate this product until
any missing or damaged parts are replaced.
REMOVE FRONT DECK BOARDS
See Figure 3.
Remove the Torx head screws from the deck boards at
the front of the crate. Remove the boards and set aside.
NOTE: Check surrounding area for screws and any other
debris that may puncture a tire.
DRIVE THE MOWER OFF THE FRAME
See Figure 4.
NOTE: Mower should be assembled while positioned on the
frame bottom. Once assembly is complete, raise the cutting
FINAL PREPARATION
Front
Rear
15 PSI
12 PSI
7 — English
deck to its highest position, release the parking brake and
slowly and carefully drive mower off frame.
WARNING:
Use care when driving the mower off of the frame and
press the brake pedal as needed to control the speed.
The mower will freely roll if it is moved on an inclined
surface without pressing the brake pedal or setting the
parking brake. Failure to follow these instructions can
result in loss of control and result in death, serious per-
sonal injury, or property damage.
Fig. 3
Fig. 4
Publicité
