Avintage AVU23TB1 Notice D'utilisation page 43

Remove the decorative nail (8) from the top left of the cabinet and install the spare top hinge (left) (7) on the
4.
top left of the cabinet with three screws (Fig. D).
Install the spare lower hinge (left) (9) according to the above procedure (Fig. E).
5.
The door opens to 180 degrees. Install the door in the same way as it was removed and fix it so that the door
6.
is aligned.
Block the hole at the top right of the cabinet with the spare decorative nail (8).
7.
Reversible shelves
In order to optimize the loading of bottles in the cellar, we have designed a special shelf that allows turning to coordinate
the inversion of the door.
In the standard configuration with the hinge on the right, A is close to the hinge and B (front with label holder) upwards
as in photo 1.
After reversing the direction of the door, you must coordinate the shelves.
1. Turn all the shelves over, A will be on the left and B will be on an downwards position.
2. Release the screw on the wooden front as shown in photo 3 so that B is upwards and fix it again.
3. Make sure that A is close to the hinge and B is upwards as shown in photo 2.
5. OPERATING INSTRUCTIONS
It is recommended that you installed your appliance in a place where the ambient temperature is
between 16-32°C. If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected and it may not be possible to obtain temperature between 5- 20°C.
The ambient temperature has an impact on the interior temperature and humidity of your cellar. For optimal
operation, the settings of your cellar are made for ambient temperatures of 23°C to 25°C.
Temperature setting
43