Publicité
Les langues disponibles
Les langues disponibles
Only run the soak program with half loads.
Options cannot be used with the soak program.
The ENERSAVE option cannot be used with soak, hygiene plus, or any programs
which do not include the final drying stage.
*
Standard programme under EN 50242 . If present, the ENERSAVE option must
be enabled.
**
See information sheet provided
***
IEC/DIN reference programme. If present, the ENERSAVE option must be
enabled.
****
Reference program for laboratories: Detergent: 20g in the dispenser + 10g in
the door or tablet. Configuration: see photo in "Using the baskets".
(1)
The cycle duration and power consumption may vary according to the water
and room temperatures, and the type and amount of dishes.
(2)
1 or 2 cold rinses depending on the model.
REFERENCES for the ENERGY LABEL supplied with the dishwasher:
-
Annual energy consumption is based on 280 standard wash cycles with
cold water and consumption of low-energy operating modes. Actual
consumption depends on the way in which the appliance is used.
-
Water consumption is based on 280 standard wash cycles. Actual
consumption depends on the way in which the appliance is used.
-
Information refers to the EN 50242 STANDARD programme (identified in
the programmes table), which is the most effective in terms of combined
energy and water consumption. The programme is recommended for dishes
with a normal level of dirt.
-
Drying efficiency class on a scale from "G" (minimum efficiency) to "A"
(maximum efficiency).
User instructions
NOTES AND REFERENCES
7
Publicité
