PCM LSW-424-15 Mode D'emploi page 2

English
1. To fix the tool holder on the machine,
introduce it on the position T09 and
tighten the screws of fixations
(Important, make sure that the screws
have the same strength of tightening).
2. Fix the reglangle to the whirling
attachment.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
LSW-424-15
3. Loose the screw, then select the correct
slip gauge (see table Sinus 0°-15°).
Re-tighten the screw and remove the slip
gauge. The reglangle is now set for the
required helix angle.
4. Loose slightly the fixation screws on the
whirling head. The head will be able to rotate
to the right and left. You can now settle the
head on the correct angle.
Controle the angle with the feeler and moving
the axe.
It must read ZERO on the measuring
instrument
Close: on ZERO, enter the result of the
whirling process.
You can thighten the fixation screws to fix the
thread-whirling head in place before running
the job.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
LSW-424-15 Mode
BT
Validation: 12.12.13
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email: office@pcm.ch
Document:
d'emploi
Page: 2 de 5