Power Dynamics PDV040 Manuel D'instructions page 7

1. SIREN SWITCH - It is used to switch the siren ON or OFF.
2. MICROPHONE VOLUME CONTROL - This knob are used to adjust the microphone volume output level.
3. LINE VOLUME CONTROL - This knob are used to adjust the LINE volume output level.
4. SIGNAL / CLIP LED - This LED will assist you in setting gain structure into the amp. With a source connected to
the amp and playing, turn up the channel gain control until this LED hust starts to flash. Once all the sources
connected are playing, the SIGNAL/CLIP LED may be on solid. This condition is normal.
5.POWER INDICATOR - This LED wil illuminae when power is turned on.
6. POWER SWITCH - This switch is used to turn the main power ON and OFF.
7. MIC INPUT JACK - They are allowed to input microphone.
8. LINE INPUT JACK - It is allowed to input auxiliary etc. Such as CD & TUNER tape.
9. MEDIA PLAYER
10. OUTPUT TERMINAL - These 3 terminals allow connecting speakers
11. GND "SCREW - In case the used mains outlet does not provide a ground conductor, this screw offers the
possibility to Ground the amplifiers metal parts. Nevertheless, you should leave this procedure to the experienced
qualified electrician.
12. DC INPUT TERMINAL - Please note the "+/-" polarity when connection DC 12V terminal in case of using
emergency power for unexpected AC power failure.
13. AC INPUT - Connector AC power mains supply and unit via the AC power cord. Before connecting this unit to
the AC supply, be sure that the voltage of appliance is in accordance with your mains supply. The fuse protects the
alternating currents supply circuit of the equipment. The fuse can only be changed in the event of a fault.
7