Geutebruck G-ST 8000+ Instructions D'utilisation page 51

To modify the language displayed in Windows, follow these steps:
2. Select a language and click "Next". The corresponding language pack is in-
3. Open the Region and Language options, by clicking Start, Control Panel and
4. Click Add a Language to access the selection menu. Select your language and
5. By clicking on your country language and on Options you access the activation
6. Activate your language by clicking "Make this the primary language" and follow
Integrating the device into the network
It is best to have the following work performed by an administrator:
1.
2.
In general, when assigning an IP address, make sure that the assigned address is in
fact available and not already assigned to another network component.
Add the desired language.

Define the desired languages as the primary language.

1. Double click on the Language icon and click "Install display languages" to open
the selection menu.
stalled.
then Language.
click "Add".
menu for the primary language.
the instructions.
Assign the G-ST the intended IP address in order to integrate it into the network.
Manual assignment of IP addresses is performed using the settings of the net-
work card of the device.
Using the console command PING, check whether the device was integrated
correctly into the network. You start the command window using right klick on
Start  left klick on Command prompt  enter PING + IP adress.
17
Back to the
table of contents
~