Publicité
Les langues disponibles
Les langues disponibles
Installation
• Position the appliance and allow it to stand for two to three
hours before it is turned on for the first time to allow the
system to settle� Do not position next to any heat source e�g�
cooker, boiler or in direct sunlight etc�
• Allow at least 10cm of space at the top and 10 cm of space
on both sides of the appliance and between the back of
the appliance and the wall for adequate air circulation� The
GB
appliance is not designed for recessed installation ("building
in")�
• Install on a good firm level surface, and any unevenness
of the floor should be corrected prior to installation, slight
unevenness can be overcome by adjusting the front feet�
• NOTE: If the appliance is positioned on a carpet, soft floor
covering you should readjust the front feet once the appliance
has had time to settle�
Use
• This appliance is designed to operate in ambient temperature
between 16°C and 38°C� If these temperatures are exceeded,
i�e� colder or warmer, the appliance will not operate correctly�
If the ambient temperatures are exceeded for long periods, the
temperature in the freezer section will rise above -18°C and
food spoilage may occur�
• Remove all packaging materials from the appliance� Wash the
34
inside of the cabinet with lukewarm water and bicarbonate of
soda (5ml to 0�5 liter of water)� Dry the appliance thoroughly�
• When you use the freezer for the first time or after defrosting,
set the thermostat control to the maximum position for at
least 2 hours before introducing food to be stored, and then
readjust to the normal position�
• If there is a power failure, do not open the door� Frozen food
should not be afected if the failure lasts for less than 19 hours �
If the failure is longer, then the food should be checked and
either eaten immediately or cooked and then re-frozen�
SETTING THE THERMOSTAT KNOB
• The refrigerator is controlled with a thermostat knob located
inside the fridge, towards the upper right-hand corner� Turn
the knob from the STOP (0) position towards the higher
numbers for colder temperatures� The knob can be adjusted
from setting 1 to 7�
• Higher settings on the knob (MAX) mean lower temperatures
(colder) in all compartments of the appliance�
• Changes of the ambient temperature affect temperature in
the interior of the appliance so choose a correct setting of
the temperature control knob, depending on your ambient
conditions�
• In the STOP (0) position the appliance does not operate (the
cooling system is switched off), but power supply is not
interrupted�
• Set the thermostat knob to a middle position to achieve -18°C
GB
35
Publicité
