Publicité
1. Place the generator on a level surface.
2. Screw the oil service door knob to "OPEN" and remove the oil service door.
3. Screw-out the oil plug, then screw-in sealing plug into the pouring orifice,
and use the funnel to add the specified amount of oil.
PREPARATION
4. Screw the oil plug, installed oil service door and keep the knob to "CLOSE".
3. Unscrew the oil plug and then screw the sealing screw into the
Recommended engine oil: SAE SJ 15W-40
pouring orifice. Use the funnel to add the required amount of oil.
Recommended engine oil grade: API Service SE type or higher
4. Screw the oil plug back in, reinstall the oil service door, and turn the
Engine oil quantity: 0.6 L
knob to the "CLOSED" position.
Recommended engine oil: SAE SJ 10W-30
Recommended engine oil grade: API Service SE type or higher
Engine oil quantity: 0.5 L
5.3 Pre-Operation check
• If any item in the Pre-operation check is not working properly, have
it inspected and repaired before operating the generator.
• The condition of a generator is the owner's responsibility. Vital
components can start to deteriorate quickly and unexpectedly,
even if the generator remains unused for a period of time.
TIP: Pre-operation checks should be made each time the generator is
used.
Pre-operation check
Fuel (See page 16)
• Check fuel level in fuel tank.
• Refuel if necessary. Be careful not to overfill!
Engine oil (See page 17)
• Check oil level and condition in engine.
• If necessary, add recommended oil to specified level or change oil.
• Check generator for oil leakage.
Oil service door
Lubricating oil pipe
WARNING
- 16 -
Oil plug
17
Publicité
