Evaluating Results - CARING MILL BM 31 Mode D'emploi

Performing a Measurement:
1.To select a desired user memory, press the +/- Buttons
until the desired user memory icon appears in the LCD
Display. Wait a few seconds until the selected user memory
icon stops flashing and the lighted ring around the START/
STOP Button shuts off. Each of the two user memories
can store 60 sets of measurements. If you do not select a
user memory, the measurement will be stored in the most
recently-used user memory.
2. With the cuff attached properly and in a correct posture,
press the START/STOP Button
will briefly display and measurement will begin after about
three seconds. To cancel a measurement at any time, press
the START/STOP Button
3. As a measurement concludes, air pressure in the Cuff will
release. The pulse symbol (
systolic and diastolic pressure.
4. _ (where the blank space is a number 1-6) will appear if
the measurement was not performed properly. Refer to the
"Troubleshooting Guide" section for details about specific
error message numbers and then repeat the measurement.
5. Press the START/STOP Button
pressure monitor. The measurement is now stored in
the selected user memory. The device will also shut off
automatically after about one minute.
6. Wait at least five minutes before taking another
measurement.
. All LCD Display elements
.
) will display, along with
to shut off the blood

7. Evaluating Results

Irregular Heartbeat:
This device can detect irregular heartbeat patterns during
measurement and will indicate them by displaying the Irregular
Heartbeat Icon .
This could be an indicator for arrhythmia, a condition where
the heart rhythm is abnormal. These symptoms (omitted or
premature heartbeats, slow or excessively fast heart rate)
may be caused, among other things, by heart disease, age,
physical predisposition, excessive use of stimulants, stress, or
lack of sleep. Only your doctor can determine if you do have
arrhythmia.
Repeat the measurement if the Irregular Heartbeat Icon
displays after a measurement. Rest for at least five minutes
between measurements and do not talk or move during
measurement. If the icon appears often, contact your doctor,
since self-diagnosis and treatment based solely on the test
results may be dangerous. It is vital to follow your doctor's
instructions.
Risk Classification
Measurements can be classified and assessed by the table
below. However, these standard values are only a general
guideline, since individual blood pressure varies in different
people and different age groups, etc.
11