Technics SB-G90M2 Mode D'emploi page 12

Placing the speakers using the spikes
The spikes may enhance the audio quality.
≥ Panasonic is not responsible for any accidents or damage caused by improper assembly or handling of the product. Do
not attach the accessories in any other way than instructed in this Owner's Manual.
≥ Each speaker has a mass of approximately 35 kg (78 lbs). When tilting the speakers to attach the spikes, ensure that the
work is done by at least two people. When attaching the spikes, exercise caution to avoid catching your fingers or toes
between the speakers and floor or tipping the speakers over. In addition, ensure that you spread a thick mat or similar item
on the side of the floor where you will be tilting the speakers to prevent damage to the floor.
≥ Each spike will be taking weights of 8 kg (17.6 lbs.) or more. This means that marks and indentations can occur in the
installation location. To prevent the spikes from damaging the area, use the supplied spike shoes or purchase spike shoes
with large contact surfaces and adequate strength.
≥ Moving the speakers with the spikes attached may cause damage to the floor. Before changing the installation location,
remove the spikes.
To avoid floor damage, have two thick mats (or similar) available. Place them in the unpacking location and the installation
location in advance.
1 Place the speaker vertically on a thick mat (or similar).
2 Remove the protective bags (2 pcs) and the cardboard covering the speaker.
3 Carry the speaker to the installation location while tilting it forward, and place it on a thick mat (or similar).
Hold the speaker so that
your hands do not touch the
speaker unit.
12
(012)