Publicité
Les langues disponibles
Les langues disponibles
1. Move the cutting depth adjustment lever;
2. Slide the base plate (2) in an upwards or downwards
direction to select the appropriate depth for the cut to be
performed;
3. Move the lever.
1. Plug in the power (11);
2. Press the ON/OFF switch (7);
This circular saw allows you to work continuously without
having to press the "ON/OFF" switch. To do this, press the
"ON/OFF" switch and then the switch lock/unlock button
(6).
3. Push the saw in the direction of the cut to be made;
4. To switch off the circular saw, release the "ON/OFF"
switch.
Before performing cleaning, adjusting, repairing and
maintenance work, switch the power tool off and
unplug the power cord. Wait for the blade to stop
completely.
The circular saw does not require any additional lubrication
or maintenance. However, you must perform regular
cleaning for a continuous and trouble-free operation.
Always keep the blade clean and sharp. Properly cared
blades jam less frequently, are more easily controlled, and
allow greater efficiency during operation.
The motor will not start if the carbon brushes are worn out.
The brushes must be replaced in time, otherwise there will
be poor contact between the brushes and the rotor, which
may lead to sparks and damage to the power tool. Both
carbon brushes should be replaced at the same time by two
brushes with equal characteristics.
1. Unscrew the carbon brush cap (12);
2. Remove the worn-out carbon brushes and install the
new ones;
3. Place the carbon brush cap and tighten.
The moving parts of the power tool must be kept constantly
greased to ensure the best performance and the expected
service life.
Lubrication should be frequent, but not excessive. Apply
only a few drops of grease, after each use, to ensure power
tool's good performance.
Publicité
