VITO PRO POWER VISCCC15110 Mode D'emploi page 29

Always wear protective gloves when installing the
saw blade.
1. Unplug the power cord;
2. Use the blade locking hex key to secure the flange (3);
3. Loosen the blade fixing bolt (4) using the key supplied;
4. Remove the bolt and flange;
5. Place the new blade on the inner flange in the direction
indicated on the blade and on the fixed blade guard;
6. Fit the flange and screw the blade fixing bolt onto the
spindle;
7. Use the two keys again to tighten the bolt;
8. Plug in the power cord and perform a test at full speed
to check for correct blade installation.
1. Fix the plastic tap (9) to the saw using the bolt;
2. Attach the supplied hose to the plastic tap.
While operating the power tool there must be certain
precautions and procedures to be observed in order to
avoid loss of control of the appliance and work pieces,
damage to the work area and injury to the user.
▪ Keep your hands away from the blade and cutting
surface, the blade can jump back at you and cause
serious injury. Always hold the circular saw with both
hands;
▪ Never hold a workpiece with your hands or use your legs
as a support while you are working. Secure the
workpiece on a stable and completely stationary surface.
It is important to properly keep the workpiece steady to
minimise the risk of kickback and loss of control;
▪ Do not have or place anything underneath the
workpiece;
▪ Adjust the cutting depth to the thickness of the
workpiece;
▪ Do not apply too much pressure on the circular saw
against the work piece/object. If the speed drops
abruptly, you must reduce immediately;
▪ Never start the circular saw when the blade is touching
the workpiece. You should only touch the blade against
the workpiece after reaching the maximum rotation
speed;
▪ When resuming the cutting operation, align the blade on
the existing cut and ensure that the blade teeth are not
touching the workpiece and the blade reaches maximum
speed. If the blade is stuck, the workpiece may move
forward or backward when the blade starts to rotate.
Keep your hands away from the blade and cutting
surface, the blade can jump back to you and cause
serious injury.