Candy CDPM 2D62W Mode D'emploi page 13

PROGRAMME SELECTION
AND SPECIAL FUNCTIONS
(Use in conjunction with programme guide)
Programme settings
Open the door and place the dirty dishes
inside the appliance.
Press the "ON/OFF" button for about 2
seconds. The display will show two lines.
Choose a programme by pressing the
"PROGRAMME SELECTION" button.
If you wish to select an option, press the
corresponding button (the indicator light
will turn on).
The option buttons can be selected or
deselected WHITIN one minute of the
programme commencing.
Press the "START" button.
The length of the program will be shown on
the display alternating
minutes [I.e: 1 h (1 hour) / 25 (25 minutes)].
When the door is shut, after an audible
signal has sounded, the programme will
start automatically. The display will show
the time remaining to the end of the cycle.
WITHIN one minute of the programme
commencing, another programme
can be selected, simply by pressing
the "PROGRAMME
button.
"IMPULSE" programmes
The "IMPULSE" programmes use an
impluse washing technology, which reduces
consumption, noise
performances.
hours with
SELECTION"
and increases
IMPORTANT
The "intermittent" working of the
washing pump
considered a malfunction, it is a
characteristic of the impulse washing
so must be considered a normal
function of the programme.
Programme interruption
Opening the door when a programme is
running is not recommended especially during
the main wash and final hot rinse phases.
However, if the door is opened while a
programme is running (for example, to add
dishes) the machine stops automatically and
the display will flash the remaining time
before the end of the cycle. Close the door,
without pressing any buttons. The cycle will
start from where it left off.
IMPORTANT
A running program can be interrupted
without opening
pressing the "ON/OFF" button. In
this case, simply press the "ON/OFF"
button again to restart the cycle from
where it left off.
WARNING!
If you open the door during the
drying cycle, an audible audio signal
advises you that the drying cycle has
not yet finished.
13
MUST NOT BE
the door by