Master Proheat STC PH-1600 Mode D'emploi page 3

Operating Instructions
HOW TO USE TRIGGER SWITCH
AND TRIGGER LOCK
Gun is Off:
a
Momentary contact trigger
switch is in Out position (not
engaged); trigger lock is in
Out position (not engaged).
b
1
To operate the gun:
1) Press the trigger switch.
Heating element and fan
start up; temperature sensor
and laser targeting system
become active; temperature
c
and airflow are adjustable
(see following pages).
To engage the trigger lock:
1) Press the trigger switch fully and hold;
2) Press the button at top of the handle;
3) Release the trigger switch.
4
( )
( )
( ) ( )
1
d
To release trigger lock:
1) Press the trigger switch;
lock button releases. If
2
trigger switch is not held in
1
manually, the gun will turn
3
Off.
www.masterappliance.com
1600/2600 Surface Temperature Control
Heat Gun
HOW TO USE PROLOC SUPERVISOR KEY
Make sure to turn the unit ON before applying key.
To change between Fahrenheit and Celsius:
Place the Proloc Key on the right side dot below the
thermometer icon.
To lock/unlock all controls:
After setting your preferred temperature units, and
dialing the temperature and airflow that is best for
your application, place the Proloc Key on the left side
dot beneath the fan icon. Repeat to unlock controls.
To change between Surface Temperature Control and
Nozzle Temperature Control (models PH-1610, PH-2610):
Place the Proloc Key on the center dot below MASTER.
Note: This mode cannot be changed when controls are
locked (see above).
Surface
Temperature
Control
www.masterappliance.com
Proloc Supervisor Key
Nozzle
Temperature
Control
5