Hilti NURON NUN 54-22 Mode D'emploi page 15

CAUTION
Risk of injury! The accessory tool may be hot and/or have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
▶ Never lay down a hot accessory tool on a flammable surface.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 6
5.2 Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
5.4 Switching starting lock on/off
The crimping tool has a starting lock that can be optionally activated or deactivated. If the starting lock
is activated, the control switch has to be pressed twice to start the crimping operation. This prevents
inadvertent starting.
The factory default is starting lock deactivated.
1. Remove the battery. → page 9
2. Press and hold down the control switch.
3. Insert the battery into the crimping tool.
4. Release the control switch.
▶ The green LED flashes twice; acoustic signal sounds twice: starting lock activated
▶ The green LED flashes twice; acoustic signal sounds once: starting lock deactivated
5.5 Inserting crimping or cutting jaws
WARNING
Risk of injury! Unintentional starting.
▶ Remove the battery before fitting, changing or removing the crimping /pressing or cutting jaws.
Never operate the product without crimping or cutting jaws in place!
1. Select the appropriate crimping or cutting jaws.
2. Press the locking pins.
*2321737*
2
2321737 English 9