Siesta ATY25FMV1B Manuel D'installation page 4

This manual provides the procedures of installation to ensure a safe and good standard of operation for the air conditioner
unit.
Special adjustment may be necessary to suit local requirements.
Before using your air conditioner, please read this instruction manual carefully and keep it for future reference.
! WARNING
• Installation and maintenance should be performed by
qualified persons who are familiar with local code and
regulation, and experienced with this type of appliance.
• All field wiring must be installed in accordance with the
national wiring regulation.
• Ensure that the rated voltage of the unit corresponds to
that of the name plate before commencing wiring work
according to the wiring diagram.
• The unit must be GROUNDED to prevent possible hazard
due to insulation failure.
• All electrical wiring must not touch the refrigerant piping
or any moving parts of the fan motors.
• Confirm that the unit has been switched OFF before
installing or servicing the unit.
• Disconnect from the main power supply before servicing
the air conditioner unit.
• DO NOT pull out the power cord when the power is ON.
This may cause serious electrical shocks which may result
in the fire hazards.
• Keep the indoor and outdoor units, power cable and
transmission wiring, at least 1 m from TVs and radios, to
prevent distorted pictures and static. {Depending on the
type and source of the electrical waves, static may be heard
even when more than 1 m away}
Disposal requirements
Your air conditioning product is marked with this
symbol. This means that electrical and electronic
products shall not be mixed with unsorted household
waste.
Do not try to dismantle the system yourself: the dismantling of
the air conditioning system, treatment of the refrigerant, of oil
and of other parts must be done by a qualified installer in
accordance with relevant local and national legislation.
Air conditioners must be treated at a specialized treatment facility
for re-use, recycling and recovery. By ensuring this product is
disposed of correctly, you will help to prevent potential negative
consequences for the environment and human health. Please
contact the installer or local authority for more information.
Batteries must be removed from the remote controller and
disposed of separately in accordance with relevant local and
national legislation.
The outdoor unit must be installed in such a way, so as to prevent short circuit of
the hot discharged air or obstruction to the smooth air flow. Please follow the
installation clearances shown in the figure. Select the coolest possible place where
intake air temperature is not greater than the outside air temperature (maximum
45°C).
Installation Clearances
Dimension A
Minimum Distance, 300
mm (in) (11.8)
Note: If there is any obstacle higher than 2m, or if there is any obstruction at
the upper part of the unit, please allow more space than the figure indicated in
the above table.
All manuals and user guides at all-guides.com
INSTALLATION MANUAL
SAFETY PRECAUTIONS
INSTALLATION OF THE OUTDOOR UNIT
B C D
1000 300 500
(39.4) (11.8) (19.7)
! CAUTION
Please take note of the following important points when
installing.
• Do not install the unit where leakage of flammable gas
may occur.
If gas leaks and accumulates around the unit, it may
cause fire ignition.
• Ensure that the drainage piping is connected properly.
If the drainage piping is not connected properly, it may
cause water leakage which will dampen the furniture.
• Do not overcharge the unit.
This unit is factory pre-charged. Overcharge will cause
over-current or damage to the compressor.
• Ensure that the units panel is closed after service or
installation.
Unsecured panels will cause the unit to operate noisily.
• Sharp edges and coil surfaces are potential locations which
may cause injury hazards. Avoid from being in contact
with these places.
• Before turning off the power supply, set the remote
controller's ON/OFF switch to the "OFF" position to
prevent the nuisance tripping of the unit. If this is not done,
the unit's fans will start turning automatically when power
resumes, posing a hazard to service personnel or the user.
• Do not operate any heating apparatus too close to the air
conditioner unit. This may cause the plastic panel to melt or
deform as a result of the excessive heat.
• Ensure the color of wires of the outdoor unit and the
terminal markings are same to the indoors respectively.
• IMPORTANT : DO NOT INSTALL OR USE THE AIR
CONDITIONER UNIT IN A LAUNDRY ROOM.
C
3
A B
D