Publicité
Les langues disponibles
Les langues disponibles
EN - Important!
Prior to assembling and using this product, carefully read and adhere to all caution
and important notices located throughout this manual. Failure to comply with these
instructions may damage the product or cause serious personal injury or death.
Due to the constant technical evolution of this product, we reserve the right to
incorporate modifications to the product for its betterment.
INSTRUCTIONS FOR ASSEMBLY AND INSTALLATION
You have just bought a technical product whose manipulation is simple without
complications if you take the following precautions. So please read all these
instructions carefully.
For the monoblock to function, it needs a skimmer (a device to vacuum the pool
water surface) It can be a skimmer built into the steel wall, or a raised skimmer
fixed to the steel wall.
To order replacement parts, please contact your supplier indicating the type and
reference number with the purchase date.
WARNING! SAFETY DETAILS FOR THE ELECTRICAL INSTALLATION
1. The electrical installation must be carried out by an approved electrician. An
automatic differential switch (30 mA) must protect the electrical supply.
In addition, the connections must conform to the directive VDE.
No reclamation will be accepted for the consequences resulting from an incorrect
installation or start-up, or for non-compliance with the instructions, the electrical
installation is subject to.
2. The electrical supply cable must not be buried.
3. Make sure that the electrical supply cable is not damaged (for example by a
lawnmower). Every damaged supply cable must be substituted straight away.
4. Keep children away from all electrical equipment. Never allow children to
operate this equipment. Parents are responsible for their children.
5. Do NOT operate the system while the pool is in use.
DETERMINING THE POSITION OF THE MONOBLOCK
Determine the place for the monoblock between the skimmer and the pump inlet
with a minimum distance of 3.5m between the pool wall and the monoblock. Cut
the area of grass (according to the size of the monoblock) and level the area with
a spirit level. We recommend placing the monoblock on concrete slabs or similar.
The monoblock must in no way be placed in a low place or directly on the earth.
(Risk of flooding or overheating of the monoblock motor)
If the pool is buried, totally or partially, the monoblock must be installed in a
filtration pit beside the pool.
When the monoblock is installed in a filtration pit, it is necessary to assure there is
no danger of flooding.
It is advisable to have a base of small stones in the base of the pit to assure a
good filtration of rainwater and the evacuation of any water in the area. It is also
advisable to install a submergible pump with a float switch in case of flooding.
Check that the installation is in no way closed hermetically, this could damage the
monoblock pump due to the formation of water condensation. The size of the pit
must be big enough to allow maintenance or repair of the monoblock.
9
Publicité
